Cart $0.00   0 items

40W 12VDC Class 2 Dimmable Driver E40L12DC-KO

40W 12VDC Dimmable Class 2 Driver is now available in a smaller compact in size. It has separate hard-wired compartments for easy install and greater reliability. This transformer works with standard TRIAC wall dimmer switch that is rated for “Low Voltage Magnetic” such as the Lutron DVLV-600P-WH.

40W 12VDC Dimmable Class 2 Driver encased in a low profile slim aluminum enclosure. Hence, it makes 40W 12VDC Dimmable Class 2 Driver a perfect choice for various other commercial and residential LED applications. Furthermore, The KO version includes a wiring compartment to enable easy-installation and eliminates the need of a J-Box.

The E series is UL certified (for sue in USA and Canada) and covered by 5-year limited warranty.

Moreover, E40L12DC-KO Class 2 Electronic Dimmable Transformer is rated to handle a maximum of 40 Watts. Hence, It is strongly recommended that maximum continuous output does not exceed 32 continuous Watts. Do not use this transformer with RGB controllers.

List of compatible dimmers for our Dimmable Drivers


40W 12VDC Dimmable Class 2 Driver Features

Dimmable with any standard TRIAC dimmer switch
Super compact Aluminium case
Class 2
UL 8750
Withstands wet and salty conditions
Auto-reset protection for short circuits, over-voltage & over-temperature
FCC 15 Part 2
12V DC True RMS

Applications

Strip/Tape Lighting
Tube Lighting
Panels
Fixtures
Cove Lighting
Bar Lighting
Kick Lighting
Under Cabinet Lighting

Technical Specifications

Max. Total Wattage 40W
Output Voltage 12VDC
Input Voltage 120 VAC 60 Hz Class 2
Efficiency >90%
Operating Temperature -30°C~70°C (-22°F~158°F)

Can be dimmed VIA hardwire with a magnetic dimmer rated for low voltage magnetic with zero voltage when off (please see instructions enclosed for further important information). Tested with Lutron DVLV-600P (or MFG Part # : DVLV-600PH-WH) Dimmer

LED Driver Installation

Accessories

  • Lutron DVLV-600P Magnetic Dimmable Switch

    Lutron DVLV-600P Magnetic Dimmable Switch easily turn the lights on, off and dim. While the lights are on, use the sleek slide control to adjust lights to your perfect level. The Magnetic Dimmable Switch returns the lights to your favourite dim level.

  • WAGO 221-413 Splicing Connector

    WAGO’s 221-415  COMPACT Splicing Connector is 40 % smaller than the 222 Series.  Accommodate 3-wire connections with stranded wires from 0.14 to 4 mm², as well as solid and fine-stranded wires from 0.2 to 4 mm² (24–12 AWG).

  • WAGO 221-415 Splicing Connector

    WAGO’s 221-415  COMPACT Splicing Connector is 40 % smaller than the 222 Series.  Accommodate 5-wire connections with stranded wires from 0.14 to 4 mm², as well as solid and fine-stranded wires from 0.2 to 4 mm² (24–12 AWG).

  • 601 Connector Wire 20AWG – 5m (16.4ft) long 6102051TFT4

    Low voltage UL/CSA listed 601 Wire 20 Gauge / Meter. Comes in 16.40 feet length. Low voltage two end pigtail wire.

  • 1 review for 40W 12VDC Class 2 Dimmable Driver E40L12DC-KO

    1. Rated 4 out of 5

      Mike T (verified owner)

      Nice packaging. Transformer / driver is quiet and stays cool at my power requirement ( only 15 W). I mounted this out of sight and inside a cupboard so lack of heat generation was important.
      The ac (110v input) and DC (12VDC output) are separate and under a common cover. I found the ac compartment very tight for the three wire connections with the marrettes / wire nuts. There is no ground lug so I slipped the bare ground wire of my supply wiring under the mounting screw. Perhaps smaller wire nuts might be available. I would recommend the manufacturer supply a proper size. These are the reasons for the 4 rather than 5 stars.
      It was great that the cable connectors were supplied as the knockouts were smaller than standard and could be hard to find.

    Add a review

    Your email address will not be published. Required fields are marked *